Operation Manual

26
FRONT PANEL AND PERIPHERAL /
CONNECT PERIPHERAL EQUIPMENT
Attention:
• After unpacking, allow the TV set to reach the
ambient room temperature before you connect the
set to the mains.
• Switch off the TV before connecting any external
device.
Via Ant Input
If you want to connect to your TV, peripherals like video
recorders or decoders, but the device you want to
connect does not have Euroconnector, you should
connect it to the ANT input of your TV set.
If the VCR is connected via antenna input it is
suggested to use the Programme 0.
Via the Euroconnector
• IYour TV set has two Euroconnector sockets. If you
want to connect peripherals (e.g. video, decoder,
etc.) which have Euroconnectors, to your TV, use
SCART1 and SCART2 inputs.
• If an external device is connected via Euroconnector
sockets TV is switched to AV mode automatically.
If the signal is RGB then the RGB OSD indicator is
displayed on the screen.
Decoder
Cable TV offers you a wide choice of programs.
Most of them are free, others are to be paid for by
the viewer. This means that you will need to subscribe
to the broadcasting organisation whose programmes
you wish to receive. This organisation will supply you a
corresponding decoder unit to allow the programmes
to be unscrambled.
For further information ask your dealer. See also the
booklet supplied with your decoder.
Connect a decoder with an aerial socket
to the TV
• Connect the aerial cable.
Connect a decoder without an aerial socket
to the TV
• Connect the decoder to your TV with a eurocable
21“ REaR PanEL
FRONT PANEL AND PERIPHERAL
A Antenna
B SCART 1
C SCART 2
CONTROL PANEL BUTTONS
CONNECT PERIPHERAL EQUIPMENT
There is a wide range of audio and video equipment
that can be connected to your TV.
The following connection diagrams show you where the
different equipment should be connected at the back or
the front side of the TV.
BDA_Superiour_SPM5521.indd 26 26.03.2007 15:54:42 Uhr