User`s manual

5-19

Chapter 5: Chassis Setup and Maintenance

Figure 5-17: Removing the Screws at the Top of the Backplane

5-11 Removing the Backplane

The SC216 chassis backplane is located behind the hard drives and in front of the

front system fans. In order to change jumper settings on the backplane, it may be

necessary to remove the backplane from the chassis.

Removing the Backplane from the Chassis

Power down and unplug the system from any power source.1.

Remove the chassis cover.2.

Disconnect the cabling to the backplane. 3.

Remove all of the hard drive trays from the front of the chassis.4.

Remove the four upper screws at the top of the backplane, indicated by the 5.

arrows below.