User`s manual

4-14
C2SEA/C2SEE User’s Manual
Hard Disk Detect Time Out
Use this feature to set the system time-out value to allow the BIOS to detect the
HDD devices installed in the system. The options are Disabled, 1, 2, 3, 4, 5, 6,
and 7 (seconds).
PCI/PnPConguration
This feature allows the user to set the PCI/PnP congurations for the following
items:
Clear NVRAM
Select Yes to clear NVRAM during system boot. The options are No and Yes.
Plug & Play OS
Select Yes to allow the OS to congure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No to
allow the AMI BIOS to congure all devices in the system.
PCI Latency Timer
This feature sets the latency Timer of each PCI device installed on a PCI bus.
Select 64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64,
96,128,160, 192, 224 and 248.
Allocate IRQ to PCI VGA
Select Yes to allow the system to give the VGA adapter card an interrupt address.
The options are Yes and No.
Palette Snooping
Select Enabled to inform the onboard PCI devices that an ISA graphics device is
installed in the system in order for the graphics card to function properly. The op-
tions are Disabled and Enabled.
PCI IDE BusMaster
Select Enabled to allow the BIOS to use the PCI busmaster to read from and write
to the onboard IDE drives. The options are Disabled and Enabled.
PCI Slot 1, 2, 4, 6, 7
Select Yes to enable OPROM for a PCI slot specied. The options are Yes (to en-
able OPROM for the slot specied) and No.
Load Onboard LAN Option ROM
Select Enabled to load the onboard LAN Option ROM. The options are Enabled
and Disabled.