Owners manual

*Mounting kits sold separately. 8/28/2015

Installation Instructions

For easy installation, you will need to:

• READ ALL the instructions completely before beginning.

• Have the necessary tools available

Tools required:

• 2 - 3/4” wrenches

• 2 - 1/2” wrenches

• 1 - C-clamp

SAFETY NOTICE: WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL OR

PERSONS WITH SOUND MECHANICAL KNOWLEDGE.

SUPERSPRINGS are designed to work in conjunction with original equipment (factory) springs only.

Please consult SuperSprings factory (866-898-0720) if original springs have been replaced with an

after-market product.

WARNING: These instructions are meant to be a general guide for installing SuperSprings. SuperSprings

International assumes no liability for the actual installation process. Consumers should apply common automotive

safety practices when raising and working on any vehicles. Do NOT put yourself in a position where if the vehicle

should move unexpectedly, you may be seriously hurt. SuperSprings are designed to improve vehicle carrying

capacity and road handling. Do NOT load any vehicle beyond the manufacturer’s specifications.

LIMITED WARRANTY

See separate warranty information page.

SuperSprings International Corporation Technical Support: 866-898-0720

505 Maple Avenue, Carpinteria, CA 93013 Email: chad@supersprings.com

www.supersprings.com gerry@supersprings.com

Prior to installation ensure the following steps have been taken:

Vehicle must be on level solid surface.

Parking brake ON - Ignition OFF.

Place blocks in front and rear of the front tires to prevent the vehicle moving.

During and / or after installation

Ensure emergency brake cables are not touching the SuperSprings blade(s). Secure them out of the

way with zip ties or by re-routing. Avoid all air conditioning lines, all fuel filler hoses and all brake

lines or cables. Position the SuperSprings so there is sufficient clearance from any frame contact both

horizontally and vertically. Also, where applicable, the ends (eye) of the SuperSprings must avoid

contact with any factory overload spring perch or bracket.

PAGE 1
Installation Instructions For easy installation, you will need to: • READ ALL the instructions completely before beginning. • Have the necessary tools available Tools required: • 2 - 3/4” wrenches • 2 - 1/2” wrenches • 1 - C-clamp SAFETY NOTICE: WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL OR PERSONS WITH SOUND MECHANICAL KNOWLEDGE. SUPERSPRINGS are designed to work in conjunction with original equipment (factory) springs only.
PAGE 2
Installation Instructions SuperSprings Model # SSA14 The SSA14 springs do have a specific left or right. Unless specified otherwise install springs with bolt threads facing outward. Position the square shouldered shackle to the rear and the sloping shackle to the front. The website includes detail color images at: http://www.supersprings.com/supersprings_installation.asp Step 1: Vehicle must be on a solid, level surface. Ensure emergency brake is ON and Ignition is OFF.
PAGE 3
8/28/2015