User guide

Grill Assembly

a. Remove two phillips pan head screws (8A) from the

side burner valve assembly (8B).

b. Carefully insert the valve assembly into the cast side

burner. You will need to angle the tube into the side

burner casting assembly (8C). Make certain that

the elbow is pointing down when the valve is put in

place. Then push the valve stem (8D) out through the

opening in the front of the side burner shelf assembly,

lining up the holes on the valve assembly with the

holes on the side burner shelf.

c. Place bezel (8E) into place, with the "OFF" position

pointing up, making sure to line up holes.

d. Attach bezel & valve to side burner shelf with screws

removed in step 8a.

e. Press knob (8F) onto valve stem assembly.

f. Unscrew the igniter button cap and install AA battery,

negative end in rst.

g. Install spring and cap assembly and tighten securely.

h. Insert the three igniter wires fed through the hole on

side of grill head into the remaining three holes.

Note: The igniter is designed in such a way that it does

not matter which terminal tab is used when connecting

igniter wires.

i. Center the brass burner cap (8G) on top of the side

burner head.

j. Place the side burner grate (8H) on to the side burner

tray.Make sure that the three larger legs rest into the

holes in the side burner tray.

STEP EIGHT