Instruction Manual

7. Pull the searing burner out a little and use an

adjustable wrench to disconnect the flex line from

the burner, then disconnect the igniter wire. (See

Fig. 7)

NOTE: Make sure the wire does not fall into the access hole.

8. Remove the searing burner.

9. Remove the (6) screws holding the front heat

shield in place.(See Fig. 8)

10. Lift the front heat shield out of the grill. (See

Fig. 9)

11. Disconnect the wires from the main burner

igniter.(See Fig. 10)

NOTE: Make sure the wire does not fall into the access hole.

12. Angle the main burner up, and set it in the

firebox. (See Fig. 11)

13. Hold the elbow on the rear IR burner valve

and use a 3/4 wrench to disconnect the flex line

from it. (See Fig. 12)

Note: Be careful, applying pressure to the elbow of the valve

may cause it to break.

14. Hold the elbow on the searing burner valve

and use adjustable wrench to remove the flex line

from it.(See Fig. 13)

Fig 8

Fig 11

Fig 9

Fig 10

Fig 12

Fig 7

SGR30M Natural Gas Conversion Instructions

Screws

Fig 13

Elbow

Flex line

Elbow on

the vale

Flex line

Hold this

elbow

Access Hole