Instruction Manual

27. Place the searing burner in to the firebox, con-

nect the flex line and then connect the igniter wire.

(See Fig. 7 on page 3)

28. Push the searing burner in position, connect the,

secure the burner with the screws removed in step

5-6. (See Fig. 5-6 on page 2)

29.Reinstall burners into the grill body. Line up the

burners with the valves on the manifold, making

sure they are level. (See Fig. 20)

30. Connect the igniter wires to the igniter. (See Fig.

10 on page 3)

31. Use the screws removed in step 4 to secure the

rear heat shield and burners in place. (See Fig. 4 on

page 2)

32. At this point of the conversion, a leak test should

be performed on all fittings. See Use and Care

manual for leak testing procedure.

33. Proceed with reattaching the front heat shield.

(See Fig. 8 and 9 on page 3)

34. Reinstall the flavor grids. (See Fig. 3 on page 2)

35. Reinstall the cooking grates

SGR30M Natural Gas Conversion Instructions

Fig 20

Fig 19