Instruction Manual

Installing the NG regulator

NOTE: Make sure to use supplied pipe sealant on all non-flared

fittings.

1. Attach the tee fitting to the manifold as shown.

Tighten with wrench. (See Fig. 21)

2. .Attach the Connector 3/8” NPT x 3/8” UNF to

the tee fitting as shown. Tighten with wrench. (See

Fig. 22)

3. Attach the NG regulator to the tee fitting.

(See Fig. 23)

4. Attach one end of the supplied hose to the flare

fitting on the side of the tee connector.

(See Fig. 24)

The other end of the hose will be attached to the

side burner later.

Note: pay attention to arrow on the NG regulator

indicating direction of gas flow. The arrow

should point toward the grill.

Remember to apply pipe sealant to all non-flared

fittings!

This completes the NG regulator installation.

Converting the Side Burner to NG

1. Use philips head screwdriver to loosen the screw

SGR30M Natural Gas Conversion Instructions

Fig 21

Fig 22

Fig 23

Fig 24

arrow on the

back of regulator