Manual

Model 318G & 618G Waterproof Tactical Light
Introduction
The Model 318GH & 618GH Waterproof Tactical light provides a rugged and reliable
source of high intensity light that is integrated into the fore-arm of the shotgun. The lamp is
shock isolated. A two button ON/OFF switch and a Pressure Switch are located on the right
side of the H18GH Housing and wired in series. The Pressure Switch is stiffened to
prevent turn on during deep submersion. When the ON/OFF switch is ON pressing on the
Pressure Switch will turn the light ON, release pressure and the light will go OFF. When
the ON/OFF switch is OFF, the Pressure Switch is deactivated. A Switch Blocker is
provided for users that want to reduce the functional size of the Pressure Switch.
Installation
1. Put safety on safe. Open action and make certain no shells remain in chamber
or magazine. Close action and remove Magazine Cap and Barrel. Reach into
bottom of receiver and press left shell latch inward. Slide Fore-End Tube off
Magazine Tube.
NOTE: Top right edge of slide may bind on bottom front of ejection port in
receiver. To free slide, push front end of bolt downward.
2. Unscrew and remove Fore-End Tube Nut using Installation Tool supplied in kit
and remove wooden Fore-End by pulling it straight off the Fore-End Tube.
3. Place H18GH Housing onto the Fore-End Tube and reinstall Fore-End Tube
Nut using Installation Tool.
4. Install Fore-End Tube on receiver by placing slide and breech bolt on the end of
the Fore-End Action Bars. Insert the end of Action Bars into matching grooves in
the Receiver. Move Fore-End gently rearward into receiver until contact is made
with front end of right shell latch. Press front of right shell latch into side of receiver.
Move Fore-End past right shell latch until contact is made with left shell latch. Press
front of left shell latch inward to allow Fore-End Tube to pass and reassemble freely
into receiver. Reassemble Barrel and tighten firmly with magazine cap.
5. Install Battery into the Housing with the + contact facing out.
6. Screw Lamp Housing into H18GH Housing.
7. Test the light using the switches, the light should come on. Installation is now complete.
Kit Contents
! H18GH Housing
! L30 or L60 Lamp Module
! DL123A or DL223AC Battery
! Model Z10 Switch Blocker
! Alcohol Wipe
! Users Manual
! Installation Tool