User Manual

8 SWAGTRON
®
SWAGSKATE NG2English
III – CHARGING
Charge the SKATEBOARD before using it.
3.1 HOW TO CHARGE THE SKATEBOARD
STEP 1. Make sure the skateboard is powered off before charging the NG2. Remove the charging port
cap, then connect the charging cable to the adapter, if not already connected.
STEP 2. Plug the charger into a wall outlet (100V-240V) then plug the other end into the charging port.
Remove the cap as needed.
STEP 3. Allow ~2 hours charging time. During charging, the adapter’s light will turn red.
STEP 4. When the skateboard is fully recharged, the adapter’s light will turn green. Disconnect the
skateboard from the adapter.
-
DO NOT under any circumstances use the skateboard while it is charging or connected to the
adapter.
- Use only the charger that comes with the NG2. If the charger is lost or damaged, please contact
customer service for a replacement. Damage caused by unauthorized chargers are not covered
under the warranty.
The charging time is approximately 2 hours. Charging longer than that may affect battery life and/or
performance. If the adapter’s light doesn’t turn on, it may not be fully connected. Check that it is securely
connected to the wall and to the skateboard. If it is, contact customer service.