User Manual

9SWAGTRON
®
SWAGSKATE NG2 English
3.2 HOW TO CHARGE THE REMOTE CONTROL
STEP 1. Make sure the remote is turned off. Connect the Micro USB charging cable to the adapter, if not
already connected.
STEP 2. Plug the charger into a wall outlet (100V-240V) then plug the other end into the Micro USB
charging port. Remove the cap as needed.
STEP 3. Allow ~2 hours charging time.
STEP 4. When the remote is fully recharged, disconnect the remote from the adapter.
DO NOT under any circumstances use the remote while it is charging or connected to the adapter.
+ The charging time is ~2 hours. Charging longer than that may affect battery life and/or performance.
3.3 SAFETY WARNINGS
- Do not place the skateboard or its battery in direct contact with heat or fire.
- Do not attempt to pierce, strike, step on, or otherwise subject the battery to any direct impact.
- Do not expose the skateboard or its battery to water or any liquids, or allow the battery to get wet.
- Do not disassemble or modify the battery.
- Do not place the skateboard on or near any source of heat or store in high-temperature locations.
- Do not place the battery in microwave ovens, high-pressure containers, or on induction cookware.
- Do not place the battery in direct sunlight or use or store the battery inside cars in hot weather.
- If the skateboard is to be used by children, explain the contents of the user manual to the children. You