Installation Guide

IMPORTANT NOTICE: Indicates that equipment or
property damage can result if instructions are not
followed.
Read and Understand the Manual
It is the responsibility of any individual who
installs or maintains this product to fully
understand and follow proper installation and
maintenance procedures. Be aware of the inherent
dangers in the use of power tools when installing this
product. Read and understand all Warnings, Cautions,
and Important Notices in this manual.
Work Safely
DO NOT proceed if any doubt arises about the
correct or safe method of performing anything
found in this or other Swanstone manuals.
The installation of this product can require using power
tools. Do not use power tools without adequate training.
If necessary, hire or consult a trained professional for
expert assistance before continuing.
Use Proper Tools
Always use proper tools which are in good,
working condition during the installation of the
Swanstone products. Using tools other than
those listed could adversely affect the integrity of floors,
pipes, walls, or this product and could result in water
damage or other damage to floors, pipes, walls, or other
portions of your building or home.
CAUTION: Indicates a potentially hazardous
situation which, if not avoided, may result in injury. It
may also be used to alert against unsafe practices.
Slipping Hazard
Do not install this product in the presence of
water. Installing this product without drying all
surfaces, or in the presence of water, could
cause you to slip and fall due to wet floors or spilled
fluids. Personal injury can result from slips or falls.
Before installation, dry all surfaces, including the floor,
with a cloth or paper towel. Clean up all water or spilled
fluids immediately.
Tripping Hazard
Personal injury can result from tripping over
power cords, tools, or other items. DO NOT
leave items laying around the work area.
Personal Protection
Be sure to use all personal protective
equipment, such as sturdy work
boots, preferably with steel toes,
gloves, and hard hat, if necessary, to ensure your own
safety. To prevent possible damage to your hearing,
always wear ear protection, such as earmuffs or
earplugs, when working around power tools.
Eye Protection
Be sure to use all personal protective
equipment to ensure your own safety. To avoid
eye injury, always wear protective glasses with
side shields when using power tools. Also, make sure
no one else can be injured by flying particles when using
power tools.
WARNING: Indicates a potentially hazardous
situation which, if not avoided, could or will result in
serious injury or death.
Fire Hazard
Personal injury or death can
result from a fire caused by
flammable liquids or silicone
sealants. Cleaners or solvents can be highly explosive,
resulting in personal injury or even death, when not used
properly. Clean up any flammable substance
immediately. Sparks or open flames can cause
flammable substances to ignite. DO NOT smoke while
working on or near any flammable substance.
Solvents Hazard
Follow all manufacturer’s safety instructions for
silicone sealants and denatured alcohol.
Alcohol vapors are both flammable and
hazardous to breathe. Silicone vapors may irritate eyes
and nose. Personal injury can result from improperly
handling or use of products such as denatured alcohol.
Always follow the manufacturer’s recommendations for
the safe use of these products. Ventilate any work area
before beginning to apply silicone sealants, cleaning
agents, or solvents.
Fumes Hazard
The fumes from the silicone and
solvents used by the installer can be
harmful if used in an unventilated
room. Always work in a well-ventilated area. To keep
the area well-ventilated, open windows and use exhaust
fans. If adequate ventilation is not achievable or
practical, use respiratory protective equipment.
Dust Hazard
When cutting, drilling, or sanding the
Swanstone product, use a dust
collection method which prevents dust
WARNING
CAUTION
IMPORTANT NOTICE
The Swan Corporation – Swanstone 4 800-325-7008
Safety Guidelines