Full Product Manual

25
Click for contents
Spotlight Detection Setup
1. Click “Clear All” to delete the default spotlight detection area.
2. To create a new spotlight detection area, press and hold the left mouse button to select
the cell or square that you want to start at, then click and drag to select the area that you
want to create. Release the mouse to finish.
3. Multiple areas can be created. Each individual square can be enabled to trigger the spot-
light. The same action also applies to delete an area that has been created.
In the example provided, a spotlight detection area has been created for the backyard and
will trigger the spotlight when one or more objects gets closer to the rear of the house.
Movement outside of the spotlight detection area will not trigger the spotlight.
Light Enable: Click the checkbox to enable the camera’s spotlight.
Light Duration: Adjust the length of time the spotlight will remain lit when motion has
been detected.
Sensitivity: Adjust the sensitivity if needed.
4. Right-click the mouse to exit.
5. Click “Apply” to save changes made.
Each single square or
cell can be enabled to
trigger the spotlight.