Full Product Manual
Table Of Contents
- Important Information
- Password Recovery
- Live View
- Live View Mode
- Live View Icons & Controls
- Main Menu
- Menu Layout
- Camera Configuration
- Display: Live
- Display: Privacy Zone
- Enabling a Privacy Mask
- Record: Mainstream
- Record: Substream
- Alarm: Detection
- Alarm: Detection - Actions
- Motion Detection Setup
- Motion Detection Tips
- Thermal-Sensing Camera Tips
- Alarm: Deterrent
- Spotlight Detection Setup
- Spotlight Trigger Schedule
- Device: PTZ
- Recording Configuration
- Record: Record
- Alarm: Detection
- Capture: Capture
- Capture: Schedule
- System Configuration
- Display: Display Configuration
- Network: Network
- Network: Email Configuration
- Network: Email Schedule
- Network: DDNS
- Network: IP Filter
- Network: Date and Time
- Device: HDD
- Device: S.M.A.R.T
- Device: Cloud Storage
- System: General
- System: Users
- Advanced: Maintain
- Advanced: Events
- Advanced: Auto Upgrade
- System Status
- System: Info
- System: Channel Information
- System: Record Info
- System: Network State
- Glossary
- Warranty Information
30
Click for contents
Record: Record
Each camera input on your DVR will be displayed as CH1, CH2, etc.
Record Enable: When disabled, your DVR will detect motion but it will not
record (manual record is also disabled).
Stream Mode: By default, your DVR will record both Mainstream and Sub-
stream video (known as DualStream). Mainstream video is used for playback
when using your DVR directly, and Substream is used for remote playback on
your mobile device. If remote playback is not required, you can select Main-
stream recording only.
PreRecord: Allows your DVR to record for a number of seconds before an
event occurs. It’s recommended to leave this enabled.
→ Use the “Copy” function to apply all set-
tings to the other cameras connected.
→ Click “Default” to revert to default settings.
→ Click “Apply” to save settings.