Full Product Manual
Table Of Contents
- Important Information
- Password Recovery
- Live View
- Live View Mode
- Live View Icons & Controls
- Main Menu
- Menu Layout
- Camera Configuration
- Display: Live
- Display: Privacy Zone
- Enabling a Privacy Mask
- Record: Mainstream
- Record: Substream
- Alarm: Detection
- Alarm: Detection - Actions
- Motion Detection Setup
- Motion Detection Tips
- Thermal-Sensing Camera Tips
- Alarm: Deterrent
- Spotlight Detection Setup
- Spotlight Trigger Schedule
- Device: PTZ
- Recording Configuration
- Record: Record
- Alarm: Detection
- Capture: Capture
- Capture: Schedule
- System Configuration
- Display: Display Configuration
- Network: Network
- Network: Email Configuration
- Network: Email Schedule
- Network: DDNS
- Network: IP Filter
- Network: Date and Time
- Device: HDD
- Device: S.M.A.R.T
- Device: Cloud Storage
- System: General
- System: Users
- Advanced: Maintain
- Advanced: Events
- Advanced: Auto Upgrade
- System Status
- System: Info
- System: Channel Information
- System: Record Info
- System: Network State
- Glossary
- Warranty Information
32
Click for contents
Capture: Capture
Each camera input on your DVR will be displayed as CH1, CH2, etc.
Auto Capture: When enabled, your DVR will take a snapshot each time an
event occurs.
Stream Mode: Leave the default selection. This allows you to select the cam-
era’s native resolution (Alarm Resolution).
Normal Interval: The length of time that must elapse before a snapshot is
taken. For example, when setting a Normal capture schedule, a snapshot
will be taken every 5 seconds using the default selection. Adjust accordingly.
Alarm Interval: When setting a Detection capture schedule, a snapshot will
be taken each time motion has been detected according to the interval se-
lected. Adjust accordingly.
Alarm Resolution: Leave the default selection. This will save each snapshot
at the camera’s native resolution. A lower resolution can be selected.
Alarm Quality: Leave the default selection. This will save each snapshot at
the camera’s highest bitrate.
As this is an added feature, a capture schedule is not enabled by default. To
enable this (see page 33 – Capture: Schedule).
As an added feature, you can enable and set a
schedule for your DVR to take a snapshot each
time an event occurs. This is particularly use-
ful for finding motion events quickly and can
also be used for different purposes such as
time lapse photography.
→ Use the “Copy” function to apply all set-
tings to the other cameras connected.
→ Click “Default” to revert to default settings.
→ Click “Apply” to save settings.