Full Product Manual
Table Of Contents
- Important Information
- Password Recovery
- Live View
- Live View Mode
- Live View Icons & Controls
- Main Menu
- Menu Layout
- Camera Configuration
- Display: Live
- Display: Privacy Zone
- Enabling a Privacy Mask
- Record: Mainstream
- Record: Substream
- Alarm: Detection
- Alarm: Detection - Actions
- Motion Detection Setup
- Motion Detection Tips
- Thermal-Sensing Camera Tips
- Alarm: Deterrent
- Spotlight Detection Setup
- Spotlight Trigger Schedule
- Device: PTZ
- Recording Configuration
- Record: Record
- Alarm: Detection
- Capture: Capture
- Capture: Schedule
- System Configuration
- Display: Display Configuration
- Network: Network
- Network: Email Configuration
- Network: Email Schedule
- Network: DDNS
- Network: IP Filter
- Network: Date and Time
- Device: HDD
- Device: S.M.A.R.T
- Device: Cloud Storage
- System: General
- System: Users
- Advanced: Maintain
- Advanced: Events
- Advanced: Auto Upgrade
- System Status
- System: Info
- System: Channel Information
- System: Record Info
- System: Network State
- Glossary
- Warranty Information
36
Click for contents
Network: Network
DHCP (Dynamic Host Configuration Protocol): Your router will automatical-
ly assign an IP address to each device connected to your network. This is
enabled by default.
If you are disabling DHCP, the following five options can be changed:
IP Address: Each device on your network must have a unique IP address. A
typical address might be “192.168.1.24” or something similar.
Subnet Mask: This allows the flow of network traffic between hosts to be
segregated based on a network configuration. A typical address might be
“255.255.255.0” or something similar.
Gateway: This allows your DVR to connect to the internet. This is typically the
same IP address as your modem or router.
DNS (Domain Name System)1/2: Input the DNS settings for your internet
service provider.
As SwannLink Peer-to-Peer technology is uti-
lised to communicate with your network and
mobile device, configuration of the network
settings is not required. If you have network-
ing expertise and require specific settings, you
do have the ability to change them.
→ Click “Default” to revert to default settings.
→ Click “Apply” to save settings.