Installation Guide

4. Once the side panel is seated on the threshold, color
coordinated caulk must be forced out beyond the finished
sides of the end panel, as shown.
5. Remove the excess color coordinated caulk to give a
finished appearance.
Note: The color coordinated caulk must not interfere with the
water return channel, visible just inside the threshold.
6. Apply a continuous bead of color coordinated caulk to the
horizontal seam between the shower floor and the side
and back panels. This color coordinated caulk seam must
start approximately 1/4" away from the beginning of the
water return channel, as shown.
Note: Do not cover any water return channels with silicone.
7. Apply a continuous bead of color coordinated caulk along
all vertical seams where side and back panels meet.
8. Immediately remove the excess caulk to give a finished
appearance.
Follow the manufacturer’s instructions on the tube for proper
application. Allow at least 24 hours for caulk to set before
using the shower enclosure.
Care and Cleaning
Swan Corporation products are stain and abrasion resistant;
however, the finish requires reasonable care.
Because cleaning products change over time, always check
the manufacturer’s instructions to make sure it is compatible
with fiberglass reinforced polyester. DO NOT use a cleaner if
the label indicates it should not be used on fiberglass
reinforced polyester. DO NOT use spray-on cleaners that
require daily use without immediately rinsing with water to
stop the chemical cleaning reaction because damage will
result and void the warranty.
Day-To-Day Cleanup
Wash regularly with warm water. Use a soft cloth with a mild
detergent such as Handy Andy, Mr. Clean, Top Job, Tough Act,
Ajax Liquid Cleaner, or Lestoil. Always rinse off cleaners
within five minutes of application. Scratch-free pads made of
nylon, saran, or polyethylene may be used.
NEVER use abrasive scouring powders, cleansers, or
scouring pads to clean the tub enclosure. They will scratch
and dull the finish. Dry cleaning agents and solvents will
damage the surface. Burning cigarettes will damage and
discolor the finish.
Caulked Joints
Alcove wall panels do not require silicone caulk, but if caulk was
applied, inspect caulked joints monthly for damage or any signs
of separation from the mating surface. Reapply caulking to any
joint showing signs of wear or cracking. Do not apply silicone
caulk into any water return channel, as shown on page 24.
Warranty
If a Swan product covered by this warranty is found to be defective in
materials or workmanship, after inspection by an authorized Swan
Corporation representative, we will repair, or at our option, exchange
the product for a similar model. This warranty extends for a
designated period of time, so long as it remains in use in its original
place of installation.
This warranty covers products installed in accordance with the Swan
Corporation’s installation instructions, used as recommended, and not
damaged due to misuse, abuse, or improper installation. It does not
apply to any seams or changes made to the product by professional
tradesmen or fabricators.
The Swan Corporation’s option to repair or exchange the products
under this warranty does not cover any labor or other costs of removal
or installation, nor shall the Swan Corporation be responsible for any
other incidental or consequential damages attributable to a product
defect or to the repair or exchange of a defective product.
Residential Limited Lifetime Warranty
The warranty applies only to the original purchaser and installation of
these products in residential applications. It does not apply to
commercial applications.
Commercial 5-Year Limited Warranty
The warranty applies only to the original purchaser and installation of
these products in commercial applications.
IMPORTANT NOTICE
IMPORTANT NOTICE
IMPORTANT NOTICE
Optional Caulking Care and Cleaning
Form # 198-03-12www.theswancorp.com
Form #198-3-14-2M