Installation Guide

8. Measure the location of the plumbing outlets (valves, tub
spout, and/or shower head). Measure from the receiving
channel edge of the back panel and measure up from the
top ledge of the bathtub.
9. Use the measurements to make a cardboard template in
order to check for proper fit around the plumbing outlets.
Trial fit the cardboard template, and adjust as necessary.
10. Transfer the template measurements to the remaining side
panel to be installed over the plumbing outlets.
Note: The filler spout and valve should be located within the
vertical area (20 to 34-1/2”) shown in the cut-a-way drawing.
Dust Hazard
When cutting or drilling, use a dust collection
method which prevents dust particles from
going into the air. Always work in a well-ventilated area. To
keep the area well-ventilated, open windows and use exhaust
fans. Always use an OSHA approved dust mask when
cutting, drilling, or sanding Swan Corporation products.
Any cutout should have rounded corners (sharp corners can
promote stress cracks).
11. Cut the clearance holes using a router, saber saw, or hole
saw. Drill or cut holes 1/2 inch larger than the diameter of
the plumbing outlets, from the finished side of the panel.
For best results, when drilling, place a scrap of wood
beneath the hole to ensure a clean cut.
12. Trial fit the panel, and make any necessary adjustments.
Note: If silicone caulking of seams is desired, refer to the
Optional Caulking section in this manual BEFORE
installing the side panel.
13. Raise the side panel approximately two inches higher than
the back panel, and slide the side panel down into the
receiving channel. If necessary, pull out slightly on the
side panel to fit over the roughed in plumbing outlets.
Note: Each side panel has three panel mounting tabs which
interlock with the companion factory installed back panel
mounting clips. The side panel must be positioned so that the
mounting tabs slide into and interlock with the back panel
mounting clips.
ABS-014a
Receiving
Channel
Side
Panel
Receiving
Channel
Side
Panel
2”
IMPORTANT NOTICE
WARNING
ABS-008
20”
34-1/2”
Locate
valve &
filler spout
within
this area.
Alcove Side
Panel
Bathtub
ABS-019
800-325-7008 9 The Swan Corporation
Bathtub Alcove Installation Procedure