Installation Instructions

6. Using the stainless steel screw installation method:
a. Pre-install the screws in the underside screw pockets.
b. Dry fit the soap shelf and mark the hole locations.
c. Drill the four mounting holes using a 3/16” drill bit.
d. Apply silicone to the back side of the shelf.
e. Attach shelf with screws.
f. Wipe off excess silicone.
Final Caulking
Apply color-matched 100% silicone sealant to all the inside
seams and exterior edges, as shown. This silicone sealant is
nonpaintable.
Follow the manufacturer’s instructions on the tube for proper
application. Allow at least 24 hours for silicone to set before
using the shower enclosure.
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
Attaching Shower Doors and Accessories
1. Follow the mounting instructions that come with each
accessory.
2. Drill pilot holes, where fasteners pass through the wall
panels, slightly larger than the fastener.
3. If anchors are being used, drill the hole in the panel large
enough for the head of the anchor to fit through the panel
and the structural wall behind it.
4. Use 100% clear or color match silicone to seal any holes
or joints between the accessory and the wall panel.
IMPORTANT NOTICE
Standard 3 Panel Optional 4 Panel Overlap
Installation Procedure
The Swan Corporation – Swanstone 16 800-325-7008