Installation Guide

5. Align the soap dish with the level-lines and press it
into place.
6. Hold the soap dish securely in place and wipe off
excess silicone. You will want a uniform bead on
both top and bottom.
7. Temporarily secure the soap dish with masking tape,
as shown. Remove the tape after approximately two
hours. Do not place anything on the soap dish for at
least 24 hours.
Installation of Sculpted Corner Soap Dish
If installing the sculpted corner soap dish, the optional
corner molding should be installed before the soap dish is
installed. Once the corner molding is in place, proceed
with Steps 1 through 7 of the “Installation of the Square
Corner Soap Dish” section.
The following illustrations show the sculpted corner soap
dish and the shower with the corner molding installed.
Corner Molding (Optional)
Installing the corner molding is optional. If the panels
were scribed and cut to create a tight-fitting corner, then
the corner molding can be eliminated. If, however, there
are gaps between the front/rear panel, the corner
molding should be installed. Either option, if done
properly, is acceptable.
If the optional soap dish was installed, cut one piece of
molding to fit above the soap dish and one for below the
soap dish.
Note: The silicone adhesive required for the installation
of the corner molding is the same as used for the
installation of the Swanstone wall panels. This kit
contains enough adhesive for both the wall panels and
the corner molding.
Installation Procedure
800-325-7008 19 The Swan Corporation – Swanstone