Installation Instructions


*
FORM #509-1-04-10M
How To Care For Your Swan or Swanstone Shower Floor
Swan and Swanstone are uniquely impervious throughout their entire thickness. They maintain their beauty in the most active environ-
ments and resist stress, thermal cracking and peeling. Use standard household liquid cleaning agents. No surface coating to wear
through. Same material throughout.
FOR SELF-CAULKING (SPEEDY SEAL) –– Using the caulking wrench pro-
vided, screw in caulking nut (clockwise) until it is tight enough to com-
press sealer. Install strainer by snapping it in the drain body.
Pressed-In Drain
Install shower floor by sliding metal drain cup over drain pipe. If
installing over no-hub or cast iron drain pipe, make sure the area
that is accepting the shower floor drain is free of nicks, cuts, or
burrs. To ensure proper seal, lightly sand drain pipe with emery
paper or “0000” steel wool. For ease of installation, lubricate both
the caulk sealer, drain cup and the drain pipe with either liquid hand
soap or dish washing liquid. Slide caulk sealer over drain pipe.
Complete installation by snapping strainer into place.
Plastic Self-Caulking Type Drain
Install drain to the shower floor. Make sure latex or silicone caulking
(not provided) is applied to the underside of drain body flanges and
secure it as shown. Do not use oil base caulking for any plastic type
drain. May cause drain to break or distort.
Shower Floors Installation Instructions
Swanstone Solid Surface and Veritek
TM
Shower Floors
The Swan Corporation One City Centre Suite 2300 St. Louis, MO 63101 p [phone] f [phone] www.swanstone.com
TYPICAL THROUGH THE WALL DETAIL
WITH A SWANSTONE PANEL SYSTEM
TYPICAL THROUGH THE WALL DETAIL
WITH AN ALTERNATIVE WALL COVERING APPLICATION
CROSS SECTION VIEW
*Rough-In Dimensions Are Suggested. Conditions May Vary For Each Installation.