Drop-In Kitchen Sink KSSB-2522 KSSB-3322 KSDB-3322 KSLS-3322 one predrilled hole and four optional hole locations, marked on the underside of the sink, for customer drilled holes.
Safety Guidelines IMPORTANT NOTICE The Swan Assurance — if our product is properly installed and maintained, as stated in these instructions, it will not leak. Remember – Safety First IMPORTANT NOTICE The Swan Corporation, the makers of the Swan products, cannot anticipate every possible circumstance that might involve a potential hazard during the installation of our product(s). The warnings and instructions in this installation guide are, therefore, not all-inclusive.
Safety Guidelines General Information Personal Protection Be sure to use all personal protective equipment, such as sturdy work boots, preferably with steel toes, gloves, and hard hat, if necessary, to ensure your own safety. To prevent possible damage to your hearing, always wear ear protection, such as earmuffs or earplugs, when working around power tools. Dust Hazard When cutting or drilling the Swanstone product, use a dust collection method which prevents dust particles from going into the air.
General Information Installation Procedure KSDB-3322 Sink Contents Confirm that all parts for the sink have been included before beginning installation.
Safety Guidelines Installation Procedure KSRB-18 B Disclaimer The information contained in this Installation Manual is given free of charge. It is based upon technical data which we believe to be reliable and is intended for use, by persons having knowledge of this technical area, at their own discretion and risk. Swanstone assumes no responsibility for results obtained or damage incurred from the use of this material either in whole or in part by the buyer. A 18-1/2” DIA.
Installation Procedure 3. 6. Measure 5/16" (8 mm) inside the initial sink outline and draw a second line inside the first. Draw a 1-1/2" radius at each corner. The second inside line will be the cutout line. If necessary, identify the location of additional holes for the faucet or other accessories and drill a 1/4” pilot hole from the back side of the sink. R 1-1/2” 5/16” KS-002 4. KS-005 7. Drill a starter hole inside of the cutout line. KS-006 KS-003 5.
Installation Procedure Care and Cleaning 14. Check for leaks. 10. Connect the drain trap fittings per the manufacturer’s instructions. a. Check water supply lines to faucet. b. Fill sink with water and check for leaks around drain. c. Release water from the sink and check for leaks in the plumbing. d. Tighten any component that is leaking and retest. The installation is now complete. DO NOT discard these installation instructions. PLEASE LEAVE THEM WITH THE HOMEOWNER.
Warranty If a Swan product covered by this warranty is found to be defective in materials or workmanship, after inspection by an authorized Swan Corporation representative, we will repair, or at our option, exchange the product for a similar model. This warranty extends for a designated period of time, so long as it remains in use in its original place of installation.