Installation Guide

2. Place two braces against each left and right wall.
3. Install (wedge) three horizontal braces (six total) against
the left and right wall braces.
4. Insert small blocks between the front-to-rear panel braces
and the back panel braces. These will apply pressure to
the back panel to hold it in place.
For corner shower wall installation use the following illustrated
bracing design.
ATTENTION: Additional bracing may be required if the
Swanstone brand panel does not make full contact to the
wall it is adhered to.
These boards need to
be attached to the two
outlying boards
Attach this
board to
the wall
Attach this
board to
the wall
5. Remove the braces after 24 hours.
Installation Procedure
800-325-7008 13 Swan