Installation Guide

1. Apply color-matched 100% silicone sealant to all of the
inside seams, as shown.
2. Also, apply color-matched 100% silicone sealant to
the exterior edges, as shown. This silicone sealant is
nonpaintable.
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
Attaching Shower Doors and Accessories
1. Follow the mounting instructions that come with each
accessory.
2. Drill pilot holes, where fasteners pass through the wall
panels, slightly larger than the fastener.
3. If anchors are being used, drill the hole in the panel large
enough for the head of the anchor to fit through the panel
and the structural wall behind it.
4. Use 100% clear silicone to seal any holes or joints
between the accessory and the wall panel.
Care and Cleaning
The Swanstone products are stain and abrasion resistant;
however, the finish requires reasonable care.
IMPORTANT NOTICE
Because cleaning products change over time, always check
the manufacturer’s instructions to make sure it is compatible
with solid surface acrylic or with fiberglass reinforced
polyester. DO NOT use a cleaner if the label indicates it
should not be used on solid surface acrylics or fiberglass
reinforced polyester. DO NOT use spray-on cleaners that
require daily use without immediately rinsing with water to stop
the chemical cleaning reaction because damage will result
and void the warranty.
Day-To-Day Cleanup
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can be
cleaned with warm water, a soft cloth, and normal household
detergents or cleansers, such as Fantastic, Formula 409,
Clorox Clean-up, Handy Andy, Mr. Clean, Dow Scrubbing
Bubbles, Lysol Foaming Tub and Tile Cleaner, Top Job,
or Lestoil. Always rinse off cleaners within five minutes of
application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
Caulking Joints
Inspect caulking joints monthly for damage or any signs of
separation from the mating surface. Cracks in the caulking will
allow water to leak into the surrounding surfaces. Reapply
caulking to any joint showing signs of wear or cracking.
Failure to inspect and repair caulking joints will void the
warranty.
Installation Procedure Maintenance & Surface Repair
Swan 16 800-325-7008