Installation Guide

Contacting live electrical wiring with power tools or hand tools
can cause serious injury or death. Make sure all related circuit
breakers are turned OFF. Test for live circuits or wiring inside
any wall where installation of the Swanstone product requires
cutting into a wall.
Electrocution Hazard
Water and other liquids conduct electric current
and can create a short circuit, resulting in injury
or death. Keep all liquids away from electrical cords and power
tools. DO NOT create a short circuit between a source of
electricity and a liquid by being in contact with both
simultaneously.
General Information
Required Tools
m 100% clear silicone sealant
m Circular saw with 60 to 80 tooth carbide blade
m Saber saw (straight up and down travel) with bi-metal blade
(14 teeth per inch)
m Drill with 3/8” drill bit
m Hole saw for shower faucet/shower head
m Tape measure
m Masking tape (2” wide works best)
m Level
m Compass or dividers (scribe the panel to the wall)
m Caulking gun
m Clean paper towels or shop towels
m 2 x 4 lumber, as required for bracing (see Bracing
Instructions)
m Industrial grade, hot glue gun and glue sticks (optional)
m Denatured alcohol
Kit Contents
Confirm that all parts of this kit have been included before
beginning installation.
SS-6296, SSST-3696-1, SSST-6296-1, SSSQ-3696-1, and
SSSQ-6296-1
One flat panel
DWP-369601
One deco panel
SK-363672, SK-363696
SK-364872, SK-364896
SK-484896, SK-366072
SK-366296
Three flat panels Two
corner moldings
Two soap shelves
One tube of
color-coordinating
silicone
STMK72-3636
STMK96-3636
STMK72-3662
STMK96-3662
SQMK72-3636
SQMK96-3636
SQMK72-3662
SQMK96-3662
Three flat panels
Two soap shelves
One tube of
color-coordinating
silicone
For best results, use 100% clear silicone sealant for bonding this
product to a properly constructed and prepared sub wall. You
will need one tube of 100% clear silicone sealant (tube sized to
fit a standard caulking gun) for every 1440 square inches or 10
square feet, or, 4 to 10 tubes for an average shower. Follow the
application recommendation located in the Panel Installation
section of this manual.
Unpackaging
m Use care when opening the box so that you do not damage
the panels.
m This product is shipped to you or your retail center after
careful inspection. After purchasing the kit, carefully unbox
and inspect the product for any shipping damage that may
have occurred. If damage is found, report it immediately to
the store of purchase. After inspection and during installation,
protect the products from construction damage by moving
them to another room or area until ready to install.
m Store panels in a flat area to avoid warpage until the time of
installation. Do not store the panels outside of the original
packaging in a vertical position.
m Please use the model number located on the side of the
box or the front of this manual when contacting us with
questions concerning the installation of this unit.
m Make sure the walls are the correct size and are in good
condition. Installation of damaged product will void the
warranty.
Swan 4 800-325-7008
Safety Guidelines General Information
SK-363672, SK-363696, SK-364872
SK-364896, SK-484896, SK-366072
SK-366296
STMK72-3636, STMK96-3636
STMK72-3662, STMK96-3662
SQMK72-3636, SQMK96-3636
SQMK72-3662, SQMK96-3662