Installation Guide

b. If the uncovered area of the back wall is less than the
width of the next panel, cut the panel to fit the opening.
It is not necessary for the seam in the back panels to
be centered, as it will be covered with the center panel.
Cut the panel from the back side with a circular saw or
a saber saw. Lightly sand the edge with fine or
medium sandpaper to remove any rough edges.
c. If a gap exists between the two back wall panels,
install a foam spacer (provided) between the two
panels and 1/4 inch from the upper edge. This foam
spacer will help fill the gap when caulking the panel.
Apply adhesive to the back of the center panel,
keeping the adhesive at least one inch from the panel
edges.
5. Firmly press the surface of each panel against the wall. It
is important to apply hand pressure to the entire surface of
the panel to bond it to the wall surface.
DO NOT force a panel to fit a bowed or curved wall as it may
break; furthermore, the resiliency of the panel can break the
silicone bond to the wall surface.
Apron Strips (optional)
If the wall and/or wall panel extends beyond the edge of the
bathtub, adding apron strips will provide a finished look to the
installation.
Two small apron strips come with the SSIT-60-3 kit or they can
be cut from scraps of a panel when using other kits. When
cutting these apron strips, make sure the finished edge of the
panel is facing outward. Trial fit the apron strips before final
installation.
1. If using the apron strips from the kit, proceed to the next
step.
If making the apron strip from the excess of a panel,
measure the distance from the edge of the bathtub to the
outside of the wall panel. Cut two pieces of the
Swanstone material at least 1/2 inch larger than the
measured distance to fit in this area.
2. Hold the apron strips in place and scribe the angle of the
bathtub base onto each piece. Remember, do not cut the
finished edge.
Fumes Hazard
The fumes from the silicone adhesive and
solvents used by the installer can be harmful if
used in an unventilated room. Always work in a well-
ventilated area. To keep the area well-ventilated, open
windows and use exhaust fans. If adequate ventilation is not
achievable or practical, use respiratory protective equipment.
3. Clean the back of the apron strip with denatured alcohol.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from properly adhering to the wall.
4. Place silicone on the back side of the apron strips.
5. Attach the apron strips to the wall.
Note: Make sure the top edges of both apron strips are
against the bottom lip of the side panels.
IMPORTANT NOTICE
WARNING
IMPORTANT NOTICE
800-325-7008 13 The Swan Corporation
Installation Procedure