Installation Guide

2. Place at least two braces against each left and right-side
walls.
3. Install (wedge) horizontal braces against the left and right
wall braces.
4. Insert (wedge) blocks or cross braces between the front to
rear panel braces and the back panel braces. These
blocks or braces must apply pressure to the back panel to
hold it in place.
5. Remove the braces after 24 hours.
6. After the temporary bracing is removed, refer to the Final
Caulking section for information on applying color-
matched caulk to joints and seams.
Final Caulking
Apply a bead of the color-matched 100% silicone sealant.
Follow the manufacturer’s instructions on the tube for proper
application. Allow at least 24 hours for silicone to set before
using the bathtub.
1. Apply color-matched 100% silicone sealant to all of the
inside seams, as shown.
2. Also, apply color-matched 100% silicone sealant to the
exterior edges, as shown. This silicone sealant is non-
paintable.
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
IMPORTANT NOTICE
Installation Procedure
The Swan Corporation 16 800-325-7008