Installation Guide

Panel Installation
Fumes Hazard
The fumes from the silicone and solvents
used by the installer can be harmful if used in
an unventilated room. Always work in a well-ventilated
area. To keep the area well-ventilated, open windows and
use exhaust fans. If adequate ventilation is not achievable
or practical, use respiratory protective equipment.
1. Clean the backs of each panel with denatured alcohol or
another non oil-based cleaning solvent.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from adhering properly to the wall.
2. Apply the silicone in 1-1/4” diameter dots every 8 to 10
inches apart over the surface of the panel. Follow the
silicone manufacturer’s instructions and all ventilation and
installation precautions.
Note: When using an industrial grade hot melt glue gun to
secure the panels to the wall in place of bracing, apply
the silicone as stated in Step 2. Then apply the hot
melt glue to the panel, as needed, and quickly press the
panel firmly into place. Also refer to the WARNING for
hot melt glue applications.
This process is not recommended for the do-it-yourself
homeowner.
Using hot melt glue in place of bracing requires application
by a qualified installer. This temporary bonding method
must hold the panel to the wall during the 24 hour curing time
of the silicone adhesive. The hot melt glue by itself is not
sufficient to bond the panel to the wall. Therefore, improper
or inadequate application of the hot melt glue may result in
insufficient bonding of the panel to the wall. Due to the
weight of the panel, failure to follow this recommendation
may allow it to detach itself from the wall, causing possible
injury to someone in or around the bathtub.
Improper installation methods may also result in water
damage or other damage to floors, walls, or other portions
of your building or home.
Do not use a home applicator, craft-type hot melt glue gun.
Using this type of glue gun will NOT hold the panels in place
long enough for the silicone to bond properly to the wall.
3. Install back panel (1) first. Then, install left-hand panel
(2). Finally, install right-hand panel (3).
4. For the SB-60-5 model, follow these steps:
a. Select any one of the four flat panels for positioning
on the back wall. Apply adhesive to the back of the
panel, keeping the adhesive at least one inch from
the panel edges.
1
2 3
IMPORTANT NOTICE
WARNING
IMPORTANT NOTICE
WARNING
The Swan Corporation 12 800-325-7008
Installation Procedure