Installation Guide

2. Dry fit the corner molding.
Fumes Hazard
The fumes from the silicone and solvents
used by the installer can be harmful if used in
an unventilated room. Always work in a well-ventilated
area. To keep the area well-ventilated, open windows and
use exhaust fans. If adequate ventilation is not achievable
or practical, use respiratory protective equipment.
3. Clean the surface of the panels and the back of the molding
with denatured alcohol or another non-oil based solvent.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from adhering properly to the wall.
4. Apply a 1/8 to 1/4 inch bead of silicone to the back of the
corner molding in an S pattern, as shown.
5. Press the corner moldings into place. Remove any
excess silicone.
6. Place at least three pieces of masking tape on each
corner molding to hold it in place until the silicone adheres
to the wall panel.
Temporary Bracing
Install the temporary bracing to hold the wall panels in place
until the silicone adhesive is completely set (usually 24 hours).
This will allow proper curing of the silicone.
To ensure contact between the panels and walls until the silicone
adhesive sets, install the temporary bracing after completing
installation. The bracing should be constructed from 1 x 2 inch,
1 x 3 inch, and 2 x 2 inch lumber. Cut the boards to length so
that the braces wedge against the wall panels and/or each other
when installed. Failure to brace in the manner described could
keep the panels from properly adhering, resulting in personal
injury, as well as water damage or other damage to floors, walls,
or other portions of your building or home.
1. Place three or more braces against the back wall. Place
two braces on the panels that are 48 inches or less and
three or four braces on the panels used on back walls
greater than 48 inches wide.
To prevent scratches or other damage, make sure there are no
nails or other foreign objects in the surface of the bracing that is
placed against the panel. Also, to prevent possible damage to
the walls, do not apply excessive pressure to the braces. Do
not hammer (pound) braces in place or nail the braces together.
IMPORTANT NOTICE
IMPORTANT NOTICE
IMPORTANT NOTICE
WARNING
Installation Procedure
800-325-7008 15 The Swan Corporation