Installation Guide
DK-346072 & DK-326072
Four flat panels
One center panel
Two corner moldings
Two soap dishes
Four tubes clear silicone
One tube color match
silicone
SK-346072 & SK-326072
Three flat panels
Two corner moldings
Two soap dishes
Four tubes clear silicone
Two tubes color match
silicone
STMK72-3662 & SQMK72-3662 (Tile Design)
Three flat panels
Two soap dishes
Four tubes clear silicone
Two tubes color match
silicone
Unpack Carton
Use care when opening the box so that you do not damage
the panels.
This product is shipped to you or your retail center after
careful inspection. After purchasing the kit, carefully unpack
and inspect the product for any shipping damage that may
have occurred. If damage is found, report it immediately to
the store of purchase. After inspection and during
installation, protect the products from construction damage by
moving them to another room or area until ready to install.
Store panels in a flat area to avoid warpage until the time of
installation. Do not store the panels outside of the original
packaging in a vertical position.
Please use the model number located on the side of the
box, or the front of this manual, when contacting us with
questions concerning the installation of this unit.
Make sure the walls are the correct size and are in good
condition. Installation of damaged product will void the
warranty.
Helpful Hints
Read these instructions carefully and familiarize yourself
with the various parts of the kit.
The variety of installations possible for this kit may require
procedures other than those shown. Ensure construction is
correctly sized, plumb, and square.
Save the large cardboard box for protection of the bathtub
during the installation process and to use as a template for
cutting the wall panels.
Allow sufficient time for the parts in this kit to adjust to room
temperature. We do not recommend installation of this
product at temperatures below 65 degrees.
Sawhorses with 2 x 4 cross-members or a worktable are
helpful during the installation process.
Always transport the panels vertically. Use care when
laying the panels flat to prevent flexing, especially when
panels have a cutout in them.
Store unused materials away from the work area to prevent
accidental damage.
If the bathtub is placed over a garage or on an outside wall,
care must be taken to ensure that the bathtub is properly
insulated from cold temperatures.
Preparation Tips
Measure the width of the back wall (with green board) installed.
This measurement cannot exceed the width of the Swan
Corporation back panel(s). If the wall opening is too small or
too large, other methods will be required to cover the wall.
Measure the height above the bathtub. If this measurement
is less than the height of the Swan Corporation back and
side panels, then the panels must be cut to fit.
Turn off the hot and cold water supply.
Remove faucet handles, escutcheons, filler spouts, and/or
anything mounted to the wall (i.e. towel bars, soap dishes, etc.).
Always measure the location of the plumbing cutouts, as
stated in the instructions, for each specific Swan
Corporation tub wall kit. Make a cardboard template to trial
fit all plumbing cutouts before cutting panels.
800-325-7008 5 The Swan Corporation
General Information
DK-346072 & DK-326072
SK-346072 & SK-326072
STMK72-3662 & SQMK72-3662