Installation Guide

3. Use the measurements to make a cardboard
template in order to check for proper fit around the
plumbing outlets. Trial fit the cardboard template,
and adjust as necessary.
4. Transfer the template measurements to the corner
side panel.
Dust Hazard
When cutting or drilling the Swan
Corporation product, use a dust
collection method which prevents dust
particles from going into the air. Always work in a well-
ventilated area. To keep the area well-ventilated, open
windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swan Corporation products.
Any cutout should have rounded corners (sharp corners
can promote stress cracks).
5. Cut clearance holes using a router, saber saw, or
hole saw. Drill or cut holes 1/2 inch larger than the
diameter of the plumbing outlets from the finished
side of the panel. For best results, when drilling,
place a scrap of wood beneath the hole to ensure a
clean cut.
IMPORTANT NOTICE
WARNING
800-325-7008 19 The Swan Corporation
Installation Procedure