Installation Guide

Do not use oil-based cleaners, such as mineral spirits, to

clean the panels. The oil in the cleaner will prevent the

panel from properly adhering to the wall.

3. Apply the silicone adhesive in 1-1/4 inch diameter

dots every 8 to 10 inches over the back surface of

the panel. Follow the silicone manufacturer’s

instructions and note all ventilation and installation

precautions.

4. Install the back panel, overlapping the corner side

panels. Carefully line up any faux grout lines.

Press the back panel firmly to the wall. Use even

hand pressure from top to bottom and side-to-side to

ensure solid wall contact.

Note: Any gaps between the bottom of the panels and

tub ledge will be filled in with caulking in a later step.

Refer to the Temporary Bracing section for information on

bracing to hold the panels in place until the silicone

adhesive is completely set (usually 24 hours). This will

allow proper curing of the silicone.

5. Install the temporary bracing to hold the wall panels

in place until the silicone adhesive cures.

6. After the temporary bracing is removed, refer to the

Caulking section for information on applying color

coordinated caulk to joints and seams.

IMPORTANT NOTICE

The Swan Corporation 22 800-325-7008

Installation Procedure