Installation Guide

Veritek Extension Kits
(Tile Design) - TI-33 and TI-55
Some extension wall panels have a flange designed to fit
against the top edge of the existing tub wall panels. Make
sure to identify and correctly orient each extension wall
panel wall before trimming panels or cutting plumbing
outlet openings.
1. Measure the height of the exposed wall above the
installed tub wall panels. If less than 24 inches, use
a saber saw to trim the top edge of the extension
panels to fit.
2. Sand the cut edge with medium grit sandpaper to
remove any rough edges.
3a. Veritek Extension Wall Kits With Separate Corner
Panels: Follow the step-by-step instructions in the
Veritek Wall Kits With Separate Corner Panels
section to cut needed plumbing outlet openings, trial
fit panels, apply silicone adhesive, and install the
panels of the extension kit.
3b. Veritek Extension Wall Kits With Corner Side
Panels: Follow the step-by-step instructions in the
Veritek Wall Kits With Corner Side Panels section to
cut needed plumbing outlet openings, trial fit panels,
apply silicone adhesive, and install the panels of the
extension kit.
Note: Keep faux grout lines and the edge of the panels
aligned when installing adjacent panels. Use even hand
pressure from top to bottom and side-to-side to ensure
solid wall contact.
IMPORTANT NOTICE
TI-33
TI-55
800-325-7008 23 The Swan Corporation
Installation Procedure