Installation Guide

4. Insert (wedge) blocks or cross braces between the
front to rear panel braces and the back panel
braces. These blocks or braces must apply
pressure to the back panel to hold it in place.
5. Remove the braces after 24 hours.
6. After the temporary bracing is removed, refer to the
Caulking section for information on applying color
coordinated caulk to joints and seams.
Caulking
Note: Install any optional extension wall panel kit and/or
optional window trim kit before caulking edges and
seams.
1. Apply a bead of color coordinated caulk to the edge
where the bottom of the tub wall panels meet the tub
ledge.
2. Apply a bead of color coordinated caulk to the top
edge of the entire unit.
3. Apply a continuous bead of color coordinated caulk
along all vertical and horizontal seams at side, back,
and optional extension panel kit and/or window trim
kit joints (if installed).
Follow the manufacturer’s instructions on the tube for
proper application. Allow at least 24 hours for caulk to set
before using the bathtub enclosure.
The installation is now complete. DO NOT
discard these installation instructions. PLEASE
LEAVE THEM WITH THE HOMEOWNER.
IMPORTANT NOTICE
800-325-7008 25 The Swan Corporation
Installation Procedure Maintenance & Cleaning