Installation Guide

Care and Cleaning
Swan Corporation Veritek products are stain and
abrasion resistant; however, the finish requires
reasonable care.
Because cleaning products change over time, always
check the manufacturer’s instructions to make sure it is
compatible with fiberglass reinforced polyester. DO NOT
use a cleaner if the label indicates it should not be used
on fiberglass reinforced polyester. DO NOT use spray-on
cleaners that require daily use without immediately rinsing
with water to stop the chemical cleaning reaction because
damage will result and void the warranty.
Day-To-Day Cleanup
Wash regularly with warm water. Use a soft cloth with a
mild detergent such as Handy Andy, Mr. Clean, Top Job,
Tough Act, Ajax Liquid Cleaner, or Lestoil. Always rinse
off cleaners within five minutes of application.
Scratch-free pads made of nylon, saran, or polyethylene
may be used.
NEVER use abrasive scouring powders, cleansers, or
scouring pads to clean the tub enclosure. They will
scratch and dull the finish. Dry cleaning agents and
solvents will damage the surface. Burning cigarettes will
damage and discolor the finish.
Caulking Joints
Inspect caulking joints monthly for damage or any signs
of separation from the mating surface. Cracks in the
caulking will allow water to leak into the surrounding
surfaces. Reapply caulking to any joint showing
signs of wear or cracking. Failure to inspect and
repair caulking joints will void the warranty.
LIMITED WARRANTY
FOR RESIDENTIAL APPLICATIONS
If a Swan Corporation product covered by this warranty
is found to be defective in materials or workmanship
after inspection by an authorized Swan Corporation
representative, we will repair, or at our option, exchange
the product for a similar model. This warranty extends
for a designated period of time, so long as it remains in
use in its original place of installation.
This warranty covers products installed in accordance
with the Swan Corporation’s installation instructions,
used as recommended, and not damaged due to
misuse, abuse, or improper installation. It does not
apply to any seams or changes made to the product by
professional tradesmen or fabricators.
The warranty applies only to the original purchaser and
installation of these products in residential applications.
It does not apply to commercial applications.
The Swan Corporation’s option to repair or exchange the
products under this warranty does not cover any labor or
other costs of removal or installation, nor shall The Swan
Corporation be responsible for any other incidental or
consequential damages attributable to a product defect
or to the repair or exchange of a defective product.
Limited Lifetime Warranty
Swan Corporation Veritek
®
Wall Panels
IMPORTANT NOTICE
IMPORTANT NOTICE
The Swan Corporation 26 800-325-7008
Warranty