Installation Guide

WARNING: Continued
Power Tool Hazard
To prevent personal injury or possible
death, always follow the electrical safety
recommendations of the power tool’s
manufacturer. Do not use power tools in an unsafe
manner. Power tools should only be connected to a circuit
protected by a ground-fault circuit interrupter (GFI).
Shock Hazard
Never use electric power tools around
water, condensation, or other liquids.
Electric shock can cause severe
burns, significant injuries, and even death. If an
extension cord is required, always use an OSHA
approved extension cord. Power cords should only be
connected to a circuit protected by a ground-fault circuit
interrupter (GFI).
Electrical Shock Hazard
Contacting l
ive electrical wiring with
power tools or hand tools can cause
serious injury or death. Make sure all
related circuit breakers are turned OFF. Test for live circuits
or wiring inside any wall where installation of the Swan
Corporation product requires cutting into a wall.
Electrocution Hazard
Water and other liquids conduct electric
current and can create a short circuit,
resulting in injury or death. Keep all
liquids away from electrical cords and power tools. DO
NOT create a short circuit between a source of electricity
and a liquid by being in contact with both simultaneously.
General Information
Required Tools
 Saber saw (straight up and down travel) with
bi-metal blade (14 teeth per inch )
 Drill with 3/8 inch drill bit
 Hole saw for faucet(s), bathtub spout, and/or shower
head
 Tape measure
 Masking tape (2 inch wide works best)
 Level
 Caulking gun
 Medium grit sandpaper
 Clean paper towels or shop towels
 Lumber as required for bracing (see Bracing
Instructions)
 Denatured alcohol
Veritek Wall Kit Contents
Confirm that all parts of the kit have been included
before beginning installation.
TF-57 Bathtub Wall Kit (Molded Design)
One back panel
One left corner panel
One right corner panel
Two side panels
Three tubes of silicone adhesive
One tube of color coordinated caulk
Designed for bathtub enclosures 58 to 60 inches wide
and 28 to 30 inches deep. Wall panels are 57 inches
high.
TI-5 Bathtub Wall Kit (Tile Design)
One left side panel with shampoo shelf
Two corner panels
One back panel with soap dish
One right side panel with shampoo shelf
One left side apron strip
One right side apron strip
Four tubes of silicone adhesive
One tube of color coordinated caulk
Designed for bathtub enclosures 53 to 60 inches wide
and 29 to 32 inches deep. Wall panels are 59-5/8
inches high.
WARNING
The Swan Corporation 6 800-325-7008
Safety Guidelines General Information