swisherinc.com OWNER’S MANUAL MODEL NO. LSRB11534 STARTING SERIAL #: L114-041001 LOG SPLITTER IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment.
LIMITED WARRANTY The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for the period's shown below beginning from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship.
SAFETY PRECAUTIONS This Safety Alert Symbol indicates important messages in this manual. When you see this symbol, carefully read the message that follows and be alert to the possibility of personal injury. Read this manual completely. This machine can amputate hands, feet, and throw objects. Failure to observe the following safety instructions could result in serious injury or death.
• NEVER operate your splitter near a flame or spark. Hydraulic oil and gasoline are flammable and can explode. • NEVER fill gas tank while the engine is hot or running. Allow the engine to cool before refueling. • This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
TOWING SAFETY • Do not allow persons to ride on splitter. Do not carry any cargo or wood on your splitter. It may fall off and endanger vehicles that are following you. • Be sure support leg is in the travel position and coupling secure. This must also be retracted so not to interfere while towing. Retract support leg by removing pin, pivoting up, and replacing pin. • Never exceed 45 MPH while towing your splitter. Be extra cautious when traveling over rough terrain, especially over railroad tracks.
ASSEMBLY This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts. Inspect all components for damage. If you believe you have a damaged part please contact customer service immediately at 1-800-222-8183. WARNING: Exercise extreme caution, as parts are very heavy. Sufficient persons or mechanical handling equipment should be used.
COLD WEATHER START UP The Cold Weather Clutch enables the engine to be started without having to pull through cold, thickened hydraulic fluid. Simply push the handle in to the locked position. Start engine, let it warm up, and release Cold Weather Clutch. SPLITTER OPERATION 1. 2. 3. Set up the log splitter in a clear, level area and block the wheels. The suction port on the tank should always be on the lower side of the log splitter. Place a log on the beam, against the foot plate.
Fluid escaping from a very small hole can almost be invisible. Do not check for leaks with your hand. Escaping fluid under pressure can have sufficient force to penetrate skin causing serious personal injury or even death. Leaks can be detected by passing a piece of cardboard or wood over the suspected leak and looking for discoloration. IF injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.
SAFETY DECALS Replace decals immediately if damaged.
Motor Base Assembly 10
SERVICE PARTS ITEM NO. QTY. 1 1 2 1 3 2 4 2 5 2 6 1 7 2 8 2 9 2 10 1 11 1 12 2 13 2 14 1 15 1 16 1 17 1 18 1 19 4 20 2 21 1 22 1 23 1 24 1 Not Shown 1 Not Shown 1 Not Shown 1 Not Shown 1 Not Shown 2 Not Shown 4 PART NO.
BEAM DETAIL ITEM NO. QTY. PART NO.
TONGUE DETAIL ITEM NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 QTY. 1 2 1 5 3 12 1 1 1 1 1 1 2 1 1 2 1 PART NO.
ENGINE DETAIL ITEM NO. QTY. PART NO. 1 3 NB253 2 1 N/A 3 4 NB170 4 1 BB105SL 5 1 9031 6 1 BB105 7 1 BB105S 8 1 TR150W 9 2 699 10 1 NB452N 11 1 NB181 12 1 NB254 Not Shown 1 6FLC Not Shown 1 7414 DESCRIPTION Bolt - Serr Flange, 5/16-18 X1 1/4 Engine, 11.5HP Nut - Serr Flange 5/16-18 Spacer - Lower For Engine Pulley Key Stock - 1/4 X 1 Pulley - Engine, 4.25"OD,1" ID Tube - Spacer 1.06 ID X 1.76 Washer - .
IDLER SUBASSEMBLY ITEM NO. QTY. PART NO. 1 1 16626TK 2 1 NB302 3 1 NB107 4 2 6037 5 1 BRS6 6 1 NB182 7 1 6040Z 8 1 B527 9 1 NB280 10 2 NB272 11 1 2077 DESCRIPTION Sliding Idler - Cold Weather Bolt - 3/8-16 X 1 3/4 Bolt - 3/8-16 X 1 1/2 Bushing - Idler Spring - Idler Arm Nut - Nyloc 3/8-16 Washer - Idler Pulley - Idler, OD-3.25", ID-3/8" Nut - 2 Way Lock 3/8-16 Washer - SAE Flat 3/8 Pivot - Handle Grip CONTROL VALVE ASSEMBLY ITEM NO. QTY . PART NO.
BELT ROUTING DIAGRAM (VIEWED FROM UNDERSIDE OF SPLITTER) TROUBLESHOOTING Problem Engine fails to start. Engine is hard to start or runs erratic. Cylinder rod will not extend or contract. Cylinder rod is slow or erratic while extending and contracting. Cause 1. Spark plug wire disconnected. 2. Fuel tank not full enough or stale fuel. 3. Throttle control lever not in correct starting position. 4. Choke not in CHOKE position. 5. Engine not primed properly. 6. Fuel valve not ON or blocked fuel line. 7.
SPECIFICATIONS LSRB11534 Splitting Force Engine Splitting Positions Cylinder Size Pump Pump Specs Valve Drive System 34 Tons* 11.5 HP Briggs and Stratton I/C Horizontal and Vertical 5" X 24" 2 Stage with Heavy Duty Bearings 16 Gallons Per Minute Auto Return Belt Drive 1:1 Ratio with Clutch for Easy Starting Hydraulic System Fluid Capacity Maximum Log length 20-24 Quarts 25 1/2" 4.00 X 4.
WIRING CONFIGURATION Wiring Harness PN 19202 18
SWISHER HISTORY Back before electricity came to rural Missouri Max Swisher was producing lawn mowers from his mother’s chicken house. Max never liked to mow grass. He installed a gearbox on his family’s lawn mower creating a self-propelled unit. By tying one end of a rope to the mower and the other end to a tree in the center of the yard the mower circled the tree, shortening the rope and guiding the mower in concentric circles. Max enjoyed relaxing under a shade tree while his invention did all the work.
LOG SPLITTER swisherinc.com OWNER’S MANUAL MODEL NO. HOW TO ORDER REPAIR PARTS: Each Log Splitter has its own serial number. Each engine has its own serial number. The serial number for the Log Splitter will be found on the right hand side of the hydraulic oil reservoir. The serial number for the engine will be found on the top of the blower fan housing. All Log Splitter parts listed herein may be ordered directly from Swisher, your nearest Swisher dealer, or from our website.
