Use and Care Manual
Table Of Contents
- Cover
- Limited Warranty
- Safety Precautions 1
- Saftey Precautions 2
- Assembly
- Operation 1
- Operation 2
- Operation 3
- Maintenance
- Troubleshooting
- Safety Decals
- Deck Leveling Detail
- Front Skirt Detail
- Hitch Detail
- Motor Base Detail
- Wheel Detail
- Height Adjust Detail
- Deck Detail
- Blade Driver Detail
- Engine Detail
- Idler Detail
- Belt Configuration
- Console Detail
- Wiring Diagram
- Fuel Tank Detail
- Carbon Canister Detail
- Battery Detail
- Battery Cable Assembly
- Hitch Positioning
- Slope Guide
- Ordering Information
㎠
Ӧ
The unit is not cutting level.
• Level deck. Check air pressure of all tires; make sure they are equal. See
tires for maximum inflation.
• Without the engine running, make certain blades are installed identically.
The engine will not start.
• Disengage blades, turn key switch to the “OFF” position, check battery and
all other electrical connections and inspect spark plug and wire.
• Contact engine manufacturer or qualified mechanic.
Engine runs poorly.
• See engine manual.
• Check the throttle adjuster.
• Replace fuel, check fuel filter and fuel line.
• Check spark plug and gap.
Cutter bounces excessively while towing.
• Decrease tire pressure.
• Tow at a lower speed.
IF PROBLEMS PERSIST HAVE A QUALIFIED MECHANIC SERVICE
THE CUTTER. NEVER ATTEMPT TO MAKE AN ADJUSTMENT THAT
YOU ARE NOT SURE IS CORRECT. DOING SO CAN CAUSE OTHER
PROBLEMS.
9
GENERAL TROUBLESHOOTING