Installation Guide

— 2 —
1. Drill two holes in the required position on the wall using a
14 mm masonry drill bit, to a depth of 75 mm.
3. Screw a fixing bolt into each fixing plug using a 8 mm
spanner until the spanner contacts the wall.
4. Place the basin in position against the wall. Locating
the fixing bolts through the holes in the rear of the basin.
Push a plastic washer followed by a metal washer, onto
each fixing bolt.
5. Screw metal nut onto each fixing bolt to secure the basin.
Do not overtighten, as this may damage the ceramic.
6. Ensure sink it secure, tighten bolts if necessary.
Install faucet and drain using manufacturer’s instructions
Connect to water supply and check for leaks.
2. Push an anchor into each hole.
Anchor Metal Screw Plastic Gasket Metal Gasket Metal Nut
WALL MOUNT SINK INSTALLATION INSTRUCTIONS