Installation Sheet

3. Determine Pipe Size

· Apply lubricant on rubber washers of straight

tube and connecting pipe, then insert into holes.

· Draw lines on pipes as pictured below.

— 2 —

2. Dry Fit Outlet Pipe and Inlet Pipe

· Fully insert straight tube into cistern flushing outlet

then connect pipe into discharge outlet.

· Draw lines to mark the finished wall location on each

pipe as pictured below.

1. Install Tank Carrier System

· Before toilet bowl installation, a wood frame and

commercial or residential tank system is required.

· Install according to manufacturer's instructions.

WALL-HUNG TOILET INSTALLATION INSTRUCTIONS

4. Cut Pipes

· Measure the distance between both marked lines

on pipe. Take measured distance, deduct from bald

end of pipe and cut pipes as shown below.

· After cutting, take a file and remove all burrs. Try

and bevel pipe edge.

L1: The distance between the two lines on the

straight tube.

L2: The distance between the two lines on the

connecting pipe.

L1 + ¹5⁄16”

L2 + ¹5⁄16”