User Manual

Remote Control
Add a transmitter:(for example)
1. Select Configure in the Main Menu interface;
2. Select Add Transmitter in the Configure interface;
3. Select the transmitter you want to add, then press the Sync Button on
the transmitter (see RECON X5TX);
4. Added successfully.
Main Interface
Select Source
Configure
General settings
Advanced Settings
Sub Menu
Recon X5
Add Transmitter
Label Transmitter
Delete Transmitter
Label Receiver
Language
Latency Mode
Wireless Channel
Audio Mode
System Information
Reset to Factory
Remark
Select the different signal source
Add more transmitters
label the transmitter
Delete the transmitter
Label the receiver
Select the language
Game Mode is default Latency Mode
Select the appropriate WIFI channel
based on the environment
LPCM is default Audio Mode
Display the system information
Restore the factory settings
Important Information
Read this user’s manual carefully before use. It contains important
information and notes regarding operating.
The RECON X5 may not apply to the below cases:
｡Repairs or product modification and alterations have been executed
by unauthorized service personnel.
｡Damages is caused by accidents including but not limited to lighting,
water, fire, or moisture.
｡Do not use power with specific power rating not compliant in the
specification.
｡The serial number on the product has been altered, deleted, removed
or made illegible.
Danger: Be careful with electricity.
｡Power to the units must be switched off before any work is undertaken.
｡When the unit is not used for a long period, disconnect them from the
power source.
Warning
｡Do not open the product.
｡Do not block the ventilation slots on the product.
｡Put the product away from direct sunlight or any source of heat.
｡Do not spill liquid on the product, especially with corrosive liquids.
｡To reduce the risk of fire or electric shock, do not expose the RECON
X5TX and RECON X5RX to rain or moisture.
Special Notice
｡Never use this product nearby an aircraft or high-accuracy electronic
instrument, It will cause an interference and wrong effect on the
operation.
｡Never use this product in the following location where wireless wave
will cause the abnormal video and audio (noise, blocked image...etc,).
1. Installed in the walls with hard accessible material.
2. This device should be situated away from the refrigerator or metal
fitment.
3. Crowded place.
｡This product has been tested and manufactured to comply with each
country’s safety rules. However, there is no guarantee that
interference
will not occur in a few particular installation. If the interference is
happened, increase the separation distance between RECON X5TX
and RECON X5RX.
｡RECON X5 is susceptible to interference from 5GHz wireless device,
such as router or other wireless device.
｡Do not put RECON X5TX and RECON X5RX in a metal rack, which
may hinder the wireless communication.
｡When wireless transmission is beginning, the product takes about
15-20 seconds to start the system, the media receiver can not be
operated during this time.
｡Do Install the external antennas before use.
1 2
3 4
The Recon X5 has built in GUI, accessible when pressing the
menu button on the remote control, aiming it towards the IR
window on the bottom of the RX. You must have a monitor
connected to either SDI output on the RX view.