Instructions

Intended use
The product is designed to switch on and off an electrical device with a
separate remote control or wireless remote control. A connected device
can also be switched on or off directly on the product. A remote control
is not included. The appropriate RSL remote controls/wireless switch-
es are available under item numbers 1574787, 1761742, 1761747,
1761748 and 1761749. The product is equipped with a child safety lock.
This product is intended for indoor use only. Do not use it outdoors.
Contact with moisture (e.g. in bathrooms) must be avoided under all
circumstances.
For safety and approval purposes, you must not rebuild and/or modify
this product. Using the product for purposes other than those described
above may damage the product. In addition, improper use can cause
hazards such as a short circuit, re or electric shock.
Read the instructions carefully and store them in a safe place. Only
make this product available to third parties together with its operating
instructions.
This product complies with statutory, national and European regulations.
All company and product names are trademarks of their respective own-
ers. All rights reserved.
Safety instructions
Read the operating instructions carefully and
observe safety instructions. If you do not follow the
safety information and information on proper
handling in these operating instructions, we will
assume no liability for any resulting personal injury
or damage to property. Such cases will invalidate the
warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may
become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong
jolts, high humidity, moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• Please handle the product carefully. Jolts, impacts or a fall even from
a low height may damage the product.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can
no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Do not use the product in rooms that are under adverse environmental
conditions, where combustible gases, vapours or dust are or may be
present! Danger of explosion!
• Always observe the safety information and operating instructions of
any other devices which are connected to the product.
• The product is de-energized only when the plug is unplugged.
• Do not put the product in a row.
• Use the product only in dry indoor areas.
• Do not use this product in hospitals or medical institutions. Although
the transmitter in the radio remote control emits only relatively weak
radio signals, these may lead to malfunction of life-support systems.
The same may apply in other areas.
• Ensure there is sufcient air circulation when you operate the product.
Never cover the product.
• If the product shows signs of damage, do not touch it, there is a risk
of death from an electric shock! First, switch off the mains voltage to
the socket to which the product is connected (switch off at the cor-
responding circuit breaker or remove the safety fuse or switch off at
the corresponding RCD protective switch, so that the socket is fully
disconnected). Only then remove the product from the mains socket.
Dispose of the damaged product in an environmentally friendly man-
ner, stop using it. Replace it with an identical product.
• The mains socket that the device is plugged into must be easily ac-
cessible.
• The product must only be powered by a standard mains socket con-
nected to the public grid. Before plugging in the product, check that
the voltage indicated on the product corresponds to the voltage of
your electricity supplier.
• Electrical devices must never be plugged in or unplugged with wet
hands.
• For safety reasons, disconnect the product from the mains socket
during storms.
• Never pour liquids over electrical devices or place objects lled with
liquid next to the product. If liquid or an object does enter the interior of
the device, power down the respective socket (e.g. switch off the cir-
cuit breaker), and then remove the mains plug from the mains socket.
Discontinue use and take the product to a specialist repair centre.
• Never use the product immediately after it has been brought from
a cold room into a warm one. The condensation that forms might
destroy the product. Furthermore, this could cause a lethal electric
shock! Allow the product to reach room temperature before connect-
ing it and putting it to use. This may take several hours.
• Consult a technician if you are not sure how to use or connect the
product, or if you have concerns about safety.
• Maintenance, modications and repairs must be carried out by a tech-
nician or a specialist repair centre.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
Operating instructions
RSL wireless socket switch
Item no. 1697440
Up-to-date Operating Instructions
Download the up-to-date operating instructions at
www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in a triangle indicates that
there is a risk to your health, e.g. due to an electric shock.
The symbol with an exclamation mark in a triangle is used
to highlight important information in these operating instruc-
tions. Always read this information carefully.
The arrow symbol indicates special information and advice
on how to use the product.
Package contents
• RSL wireless socket switch
• Operating instructions
Product overview
1 Wall outlet
2 Combination switch with
LED light
3 Mains plug (back, not
visible)
1
3
2
Programming
Each radio receiver of the RSL system can teach up to 8
different remote controls. A radio-controlled switch socket
features 8 memory spaces for different channels or remote
controls.
Please refer to the operating instructions for the remote
control you are using. Some of following descriptions may
differ.
• Set the desired switching group (I, II, III or IV) on the remote control
(not included in the delivery) with the switching group-selector switch.
• Plug the wireless socket switch into a household power socket. The
combination switch with LED (2) starts to ash. This indicates that
the wireless socket switch is ready for pairing with a remote control.
Do not put the product in a row.