Operation Manual

16
§DISK BRAKE INSPECTION§(Applicable for model equipped with disc brake.)
 Visual check brake lines for leakage, or damage, check
brake lines connections for looseness using a wrench or
similar tool, and check whether steering handle vibration in
driving, or any parts’ interference may have damage the brake
lines. If so, bring your scooter to your SANYANG dealer for
repairing or service.
（leak, damaged, looseness of brake line）
（Checking front brake lining）
 check the brake from behind the brake
caliper. The brake pad must be replaced with
new lining when the brake pad wear limit
reaches the brake disk.
（Checking oil quantity in brake oil reservoir）
 Park the scooter on a lever ground, and
check if fluid lever is under the “LOWER”
mark. Recommended Brake Fluid: WELL
RUN BRAKE OIL (DOT 3).
（Replenishment of front wheel brake fluid）
1.Loosen the screws and remove the master cylinder cover.
2.Wipe clean foreign materials, dirt around the reservoir, being
careful not to let foreign materials fall into the reservoir.
3.Remove the diaphragm plate and the diaphragm.
4.Add brake fluid to upper lever.
5.Install the diaphragm plate and the diaphragm, and install the
master cylinder cover.
6.please note the diaphragm direction, and do not let foreign
materials fall into the reservoir. And tighten the master cylinder
cover securely.
CAUTION:
 TO prevent chemical reaction, please do not use brake fluids other than those recommended.
 Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or plastic
components to prevent damage.
CAUTION:
 Please drive your motorcycle on a dry road surface
slowly and operate front and rear brakes in order to
find out if there is any malfunction so as to ensure
the motorcycle is at optimum condition and safe
ride. .
Brake
disk
Brake
caliper
Brake
pad wear
limit grooves
Screw
Master cylinder
cover
Diaphragm
Uppe
r
Brake fluid