Installation Guide

Dia

Model Number Speciﬁcation

Modiﬁcations

Dimensions

Note: Dimensions subject to change without notice.

Compliance

Warranty

Limited Lifetime - to the original end purchaser in

consumer installations.

5 Years - for commercial installations.

Refer to www.symmons.com/warranty for complete

warranty information.Note: Append appropriate -sufx to model number.

352SH

352SH-3

352SH, 352SH-3

Showerhead Series

Operation & Maintenance Manual

☐

352SH 1 Mode Showerhead

☐

352SH-3 3 Mode Showerhead

☐

-1.5 1.5 gpm (5.7 L/min) ﬂow restrictor

☐

-2.0 2.0 gpm (7.6 L/min) ﬂow restrictor

• 1 mode showerhead (352SH)

• 3 mode showerhead (352SH-3)

• 3" diameter

• Easy to clean rubber nozzles

• 2.5 gpm (9.5 L/min) standard ow restrictor

- ASME A112.18.1/CSA B125.1

- WaterSense 1.5 gpm, 2.0 gpm

Measurements

A 4-1/4", 108 mm

B 4-1/8", 105 mm

C 4-3/4", 121 mm

D 4-1/2", 114 mm

Certied by

CSA Group

PAGE 1
Dia ® 352SH, 352SH-3 Showerhead Series Operation & Maintenance Manual Model Number ☐ 352SH ☐ 352SH-3 Specification 1 Mode Showerhead • • • • • 3 Mode Showerhead Compliance Modifications ☐ -1.5 ☐ -2.0 CG 1 mode showerhead (352SH) 3 mode showerhead (352SH-3) 3" diameter Easy to clean rubber nozzles 2.5 gpm (9.5 L/min) standard flow restrictor - ASME A112.18.1/CSA B125.1 - WaterSense 1.5 gpm, 2.0 gpm 1.5 gpm (5.7 L/min) flow restrictor 2.0 gpm (7.
PAGE 2
Installation Tools Required for Installation Plumber Tape 1) Install showerhead to shower arm (not included) turning clockwise to tighten. 1 2 Operation 1) Turn showerhead to desired mode of operation. Troubleshooting Chart Problem Cause Solution Finish is spotting. Elements in water supply may cause water staining on finish. Showerhead is leaking from shower arm when valve is in "on" position. Coupling connecting showerhead to shower arm is cracked.