User's Manual

12
Chapter 2: Hardware Setup
Remove a Memory Module from Synology NAS
Follow the steps below to remove, install, or check a memory module on your Synology NAS.
To remove the memory module
1
Shut down your Synology NAS. Disconnect all cables from your Synology NAS to prevent possible damage.
2
Remove the hard drive trays from the drive bays. The memory slot is located on the inner right side of your
Synology NAS.
Note:
When you remove the drive trays, sensitive internal components are exposed. Avoid touching anything other
than the memory assembly when removing or adding memory.
3
Push the levers on both sides of the memory module outward. The memory module will be released from its
slot.
4
Hold the memory module by its edges and remove it from the slot.
5
Insert the drive trays back into the drive bays.
6
Reconnect the cables removed in step 1, then press the power button to turn on your Synology NAS.