User Manual

Table Of Contents

Tools and Parts for Component Installation

Please prepare the tools and parts below before setting up your Synology NAS:

• A Screwdriver

• At least one 3.5” or 2.5” SATA drive (please visit

www.synology.com/compatibility

for compatible drive

models)

Warning:

If you install a drive that contains data, the system will format the drive and erase all existing data. Please

back up any important data before installation.

Install Drives

1 Push the upper case in the direction as shown below. Lift the upper case and set it aside.

2 Install drives:

• For 3.5” drives with 3 screw holes on each side (indicated below):

a Slide the drive into the hard drive bay, and push it all the way until it’s rmly connected to the SATA

connector.

b Secure the drive with the screws provided.

• For 3.5” drives with 2 screw holes on each side (indicated below):

a Place the HDD bracket on your Synology NAS, and fasten the bracket to the Synology NAS with the

screws provided.

Hardware Setup

Chapter