User Manual

9 Chapter 2: Hardware Setup
b Slide the drive into the hard drive bay, and push it all the way until it’s rmly connected to the SATA
connector. Secure the drive with the screws provided.
• For 2.5” drives:
a Place the drive in the 2.5" Disk Holder (Type C, sold separately), and then tighten the 2.5" screws to
secure the drive.
b Slide the 2.5" Disk Holder into the hard drive bay, and push it all the way until the drive is rmly connected
to the SATA connector. Secure the Disk Holder with the provided screws.
3
Repeat the steps above to install the other drive if you have prepared one.
4 The position of drives is as follows:
Note:
If you want to create a RAID volume, we recommended that all installed drives are of the same size to make
the best use of drive capacity.