User's Manual

ManualsBrandsSynology ManualsComputersM.2 SSD & 10GbE Combo Adapter Card

1

2

3

4

5

6

7

8

9

Table Of Contents

Synology Adapter Card E10M20-T1 Hardware Installation Guide
- Chapter 1: Before You Start
- Chapter 2: Hardware Setup
  - Tools and Parts for Installation
  - Attach M.2 SSD to E10M20-T1 Adapter Card

10

Chapter 2: Hardware Setup

c

Remove the protective lm from the thermal pad and attach the thermal pad to the controller of SNV3500-

400G. Attach the rubber next to the screw pillar.

d

Repeat previous three steps if installing another M.2 SSD is needed. Slots are numbered as shown below.

1

2

e

Tighten the heatsink with four screws. Please make sure the heatsink is rmly attached to the adapter

card to ensure the smooth running of the M.2 SSD.