User's Manual
Table Of Contents
16
Chapter 2: Hardware Setup
To remove the RAM Module
1
Follow step 1 and 2 of the "
To install the RAM module
" section to shut down your RS4021xs+, disconnect the
cables, and then remove the rear top cover as described above.
2
Cut the cable tie before removing the memory module. (The pre-installed memory module is cable-tied to
prevent it from loosening during delivery.)
Note:
Avoid touching any components on the motherboard when cutting the cable tie.
3
Push the retaining clips on the slot out to the sides. The memory module will pop out of the slot.
4
Follow step 4 of the "
To install the RAM module
"
section to fasted the top cover back in place.