User Manual

21
Basic Removal/ Inst allat ion
Procedures 6
Int roduct ion
t o This Sect ion
Th is section gives basic procedures for rem ovin g an d in stallin g th e XTS 3000
radio’s:
• An ten n a,
• Battery,
• Belt Clip,
• Un iversal Con n ector Cover,
• Volum e Kn ob, an d
• Frequen cy Kn ob.
Ant enna
Installing the
Antenna
Screw th e th readed en d of th e an ten n a in to th e an ten na receptacle on th e top
of th e radio. Rotate th e an ten n a clockwise un til it seats firm ly again st th e
bush in g.
Removing the
Antenna
Rotate th e an ten na coun terclockwise un til its th readed en d un screws from th e
radio’s an ten n a receptacle.
Bat tery NOTE: Th e battery is sh ipped un ch arged, an d m ust be
ch arged before use.
To avoid a possible explosion:
• DO NOT replace t he bat t ery in an area labeled
“hazardous at mosphere.”
• DO NOT discard bat t eries in a fire.
!
W A R N I N G
!
If your radio is programmed with volatile-key retention
(consult your service technician), encryption keys will be
retained for approximately 30 seconds after battery removal.
!
C a u t i o n